Foren: Hilfe (Thread #11762)

HALT after powering on H8/MAX (2006-07-16 21:11 by Anonym #23771)

Dear Sirs:

I am an engineer from Taiwan.
I have one question about H8/MAX board.
Please, first, accept my apology that I can't read and write Japanese.

After powering on the H8/MAX board,
the boot process started and I got some text message from Windows HyperTermnal.
But I found that the boot process halted abnormally.
The message started with:
inflating binary .................
but halted at:
eth0: NE2000 found at 0x800600, using IRQ 16.
Blkmem copyright 1998,1999 D. Jeff Dionne
Blkmem copyright 1998 Kenneth Albanowski
Blkmem 1 disk images: 0: 4F8A88-518687 [VIRTUAL 4F8A88-518687] (RO)
Uniform Multi-Platform E-IDE driver Revision: 7.00beta4-2.4
ide: Assuming 50MHz system bus speed for PIO modes; override with idebus=xx

According to the H8/MAX document,
the message should be continued with:
hda: SanDisk SDCFB-64, CFA DISK drive ide0 at 0x00200000-0x0020000f,0x0060000c on irq 17
hda: attached ide-disk driver.
and finally command shell should be loaded.

Your response will be greatly appreciated.

Reply to #23771×

You can not use Wiki syntax
You are not logged in. To discriminate your posts from the rest, you need to pick a nickname. (The uniqueness of nickname is not reserved. It is possible that someone else could use the exactly same nickname. If you want assurance of your identity, you are recommended to login before posting.) Anmelden

RE: HALT after powering on H8/MAX (2006-07-20 14:25 by ysato #23860)

It should be so that cannot identify CF.
Cannot you test it with other CF?
Reply to #23771

Reply to #23860×

You can not use Wiki syntax
You are not logged in. To discriminate your posts from the rest, you need to pick a nickname. (The uniqueness of nickname is not reserved. It is possible that someone else could use the exactly same nickname. If you want assurance of your identity, you are recommended to login before posting.) Anmelden